- 您现在的位置：买卖IC网 > Sheet目录878 > RSS1C101MCN1GS (Nichicon)CAP ALUM 100UF 16V 20% SMD
Precautions
(4) If the gas gets in your eyes, rinse them immediately. If it has been inhaled, gargle with water immediately.
(5) When the polymer or gas of the polymer comes in contact with your skin, wash it off with soap and water.
(6) The electrolyte, separator paper, rubber and tube used in the FPCAP are all combustible. When the current value is
extraordinarily high during a short circuit, and assuming the worst possibility, the shorted-out section in the lead wire or
inside the capacitor could create a spark, and cause the resin or tube to catch fire.
Give due consideration to the capacitors mounting methods, mounting positions, pattern design etc.
5. Storage conditions
Do not store capacitors without load more than a year because of potential increased leakage current.
(1) Do not store at high temperatures and high humidity. Store it in a location that is not subject to direct sunlight and that has
low temperatures and humidity (generally, temperatures between 5 and 35oC and a relative humidity of 75% or less).
(SMD type VA/VB series : Temperatures between 5 and 30oC and a relative humidity of 70% or less)
(2) Storage period (SMD type VA/VB series)
Store in an aluminum laminated bag.
Before opening : 1 year
After opening : 1 week (Use up all the products after having opened out. Surplus products should be put into the aluminum
laminated bag, and seal up.)
(3) Baking conditions (SMD type VA/VB series)
When you use it exceeding a storage term, please carry out and use baking by the following conditions.
Temperature: 60(+0, -5) oC
Time: 168hours (only one time)
(4) Store in an airtight plastic bag to keep the leads in good condition.
(5) To keep the leads in good condition, store lead-type the FPCAP for no more than one year.
(6) Do not store in places where water, salt water or oil can directly fall on them, or places where condensation may form.
(7) Do not store in places filled with noxious gas (hydrogen sulfide, sulfurous acid, nitrous acid, chlorine, ammonia, etc.).
(8) Do not store in places exposed to ozone, ultraviolet rays and radiation.
6. Disposal
Please treat the FPCAP as industrial waste when needing to dispose of the FPCAP .
For details, refer to the Operating Precaution Guidelines for the EIAJ RCR-2367C. (Safety Application Guide for fixed
aluminum electrolytic capacitors for use in electronic equipment.)
No part of this publication shall be reproduced without prior written permission of the publisher.
NICHICON CORPORATION / FPCAP ELECTRONICS (SUZHOU) CO., LTD.
5
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
RSZ-3.33.3/P-R
CONV DC/DC 1W 3.3VIN 3.3VOUT
RTS-243.3-R
CONV DC/DC 2W 24VIN 3.3VOUT
RU-3.30505/HP
CONV DC/DC 1W 3.3VIN 0505VOUT
RUZ-050505/P
CONV DC/DC 2W 05VIN 0505VOUT
RVB0G151MNG
CAP ALUM 150UF 4V 20% SMD
RW-4815D
CONV DC/DC 3W 36-72VIN +/-15VOUT
RW-483.3S/SMD
CONV DC/DC 3W 36-72VIN 3.3VOUT
RW2-483.3D/H3/SMD
CONV DC/DC 2W 36-72VIN +/-3.3V
相关代理商/技术参数
RSS1E100MCN1GS
功能描述:铝有机聚合物电容器 10UF 25V 20%
RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel
RSS1E220MCN1GS
功能描述:铝有机聚合物电容器 22UF 25V 20%
RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel
RSS1E270MCN1GS
功能描述:铝有机聚合物电容器 25V 27uF 20% Tol.
RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel
RSS1E470MCN1GS
功能描述:铝有机聚合物电容器 25V 47uF 20% Tol.
RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel
RSS1E560MCN1GS
功能描述:56μF 25V Aluminum - Polymer Capacitors Radial, Can - SMD 30 mOhm 2000 Hrs @ 105°C 制造商:nichicon 系列:FPCAP，RSS 包装:剪切带（CT） 零件状态:有效 电容:56μF 容差:±20% 额定电压:25V ESR（等效串联电阻）:30 毫欧 不同温度时的使用寿命:105°C 时为 2000 小时 工作温度:-55°C ~ 105°C 极化:极化 应用:通用 纹波电流:2.8A 阻抗:- 引线间距:- 大小/尺寸:0.248" 直径（6.30mm） 高度 - 安装（最大值）:0.236"（6.00mm） 表面贴装焊盘尺寸:0.256" 长 x 0.256" 宽（6.50mm x 6.50mm） 安装类型:表面贴装 封装/外壳:径向，Can - SMD 标准包装:1
RSS1E680MCN1GS
功能描述:68μF 25V Aluminum - Polymer Capacitors Radial, Can - SMD 30 mOhm 2000 Hrs @ 105°C 制造商:nichicon 系列:FPCAP，RSS 包装:剪切带（CT） 零件状态:有效 电容:68μF 容差:±20% 额定电压:25V ESR（等效串联电阻）:30 毫欧 不同温度时的使用寿命:105°C 时为 2000 小时 工作温度:-55°C ~ 105°C 极化:极化 应用:通用 纹波电流:2.8A 阻抗:- 引线间距:- 大小/尺寸:0.248" 直径（6.30mm） 高度 - 安装（最大值）:0.236"（6.00mm） 表面贴装焊盘尺寸:0.256" 长 x 0.256" 宽（6.50mm x 6.50mm） 安装类型:表面贴装 封装/外壳:径向，Can - SMD 标准包装:1
RSS1R50J
制造商:KOA Speer Electronics Inc 功能描述:.5 ohm Through Hole Resistor METAL OXIDE 1W 5% AXIAL CUT TAPE
RSS1V100MCN1GS
功能描述:10μF 35V Aluminum - Polymer Capacitors Radial, Can - SMD 60 mOhm 2000 Hrs @ 105°C 制造商:nichicon 系列:FPCAP，RSS 包装:剪切带（CT） 零件状态:有效 电容:10μF 容差:±20% 额定电压:35V ESR（等效串联电阻）:60 毫欧 不同温度时的使用寿命:105°C 时为 2000 小时 工作温度:-55°C ~ 105°C 极化:极化 应用:通用 纹波电流:1.7A 阻抗:- 引线间距:- 大小/尺寸:0.248" 直径（6.30mm） 高度 - 安装（最大值）:0.236"（6.00mm） 表面贴装焊盘尺寸:0.256" 长 x 0.256" 宽（6.50mm x 6.50mm） 安装类型:表面贴装 封装/外壳:径向，Can - SMD 标准包装:1